[Date Prev][Date Next][Thread Prev][Thread Next][Minivend by date
][Minivend by thread
]
Re: [mv] Search Results Problem
****** message to minivend-users from Ramsey French <rammjet@mindspring.com> ******
On 1/10/00 7:56 PM, Ryan Hertz at rhertz@gyb.baits.com wrote:
> ****** message to minivend-users from Ryan Hertz <rhertz@gyb.baits.com>
> ******
>
> At 11:55 AM 1/9/2000 , you wrote:
>> ****** message to minivend-users from Ramsey French
>> <rammjet@mindspring.com> ******
>>
>> My site uses nested frames and I am trying to get the "simple" srchform and
>> results page to work with it.
>>
>> Mike Heins previously gave me the suggestion to use [process-target frame]
>> and set mv_doit to "search".
>>
>> Every time the results page comes up in its frame, it says my searchspec
>> wasn't found. However, when I have it print mv_search_match_count, it
>> contains the correct number of results for my sample search.
>>
>> So, something is happening on the results page that causes it to bypass the
>> [more-list] and [search-list] sections and go straight to the [no match]
>> section.
>>
>> Can anyone suggest an error condition that might cause this to happen?
>
> Uh, perhaps the value is sent to the wrong frame.
Thanks, but I have tested mv_search_match_count in the target frame and it
prints the correct number and it prints it in the correct frame. But for
some reason, it skips straight to the [no-match] section.
I am running some test cases to see if I can get any more insight. But the
docs say that [no-match] will be achieved if there are no matches, or other
errors. I think I have the matches, so I am interested in what errors can
cause it to skip to [no-match].
-
To unsubscribe from the list, DO NOT REPLY to this message. Instead, send
email with 'UNSUBSCRIBE minivend-users' in the body to Majordomo@minivend.com.
Archive of past messages: http://www.minivend.com/minivend/minivend-list