|
|
|
|
Mike,
Thanks for the cpan_local_install, I've tried the V 0.2, and it has installed what i think is all the
required CPAN modules to my home ( home/mysite/Interchange ) directory
on my ISP
virtual server.
I then tried to run :- perl Makefile.PL make make test && make install but 'perl
Makefile.PL' kept asking me the same questions as your cpan_local_install
script and so
kept running into installation problems as if i was running ./configure
script.
Mike, correct me if I'm wrong, was this cpan_local_install script mean't to replace Makefile.PL. If so, I have looked at the Makefile.PL script but cannot located the point I need to start
from inorder to finish off the Interchange 4.5.7 installation/setup, and to
setup the demo.
Can you or anybody advise further. Thanks Hansraj |