|
|
|
|
Im running (well trying to) minivend on a FreeBSD
3.3 system, following
the install instructions i unarchived the tarball
into out source directory
then configured, made, tested and installed
minivend.
there were no errors and the tests seemed to work,
however when
i went to setup the simple example i was unable to
find the makecat
command, infact the entire bin directory was not
there.
Is there something i have not done?
I have full write access on the server, was using
SU when installing
and as mentioned there were no error
messages.
Regards
Andrew Hooper
andrew@best.net.nz
|