|
Thanks for the quick response.
There are 3 areas above in the Area section -
every - , and below this there are 2 'all' selections for 'all' seperated
by a 'blank'
Below this is the 'page class' which defaults to
'all' ( i am beginning to feel real stupid on this one)
Strike the above..
/products/area.txt ... I can edit this with no
problem..
What I finally did was to do the
following
1. Went to the Design area.
2. Creat new section
3. Page class (typed in all) (the area showed
default to all on the left)
4. Page area left
5. Nothing happened so under 'link type'
I selected simple search.
7. I then went back and selected no
link
8. Finally I moved
an Available categorie over to the
Contains: area
9. Restarted the program and it worked.
Thanks for the help BUT I think that I am doing
this Bass Ackward
Jerry Davis
----- Original Message -----
Sent: Tuesday, November 21, 2000 11:07
AM
Subject: Re: [ic] Add new Section
Problem
There's an multioption called "pages" that shows 1
option: all.
Make sure it's selected.
Jerry Davis wrote:
Hello all
I can not add an new heading via the
'Design area'
IF I fiddle around It will show the heading in the admin
'Area -- section:'
but not on the main page.
I have installed the
6.0 numerous times with out any problems. Ownership is
not the problem
as I can Delete any areas I want' and add new Available
categories:
I have done the obvious : Apply Changes and (or) restart Interchange.
Any and all help would be appreciated.
Thanks
Jerry Davis
Using the tarball version under Linux 5.2
Thanks again
_______________________________________________
Interchange-users
mailing list
Interchange-users@www.minivend.com
http://www.minivend.com/mailman/listinfo/interchange-users --
Marcel Montes [marcel(at)multimake(dot)com] - Programmer
"If our brain were so simple that we could understand it,
we would be so stupid that we couldn't do so"
-------------------------- EOF ----------------------------
| 
