RE: [mv] [mv 4.02] - make test fails

["Christopher Thompson" <ct@arborinternet.com>]

******    message to minivend-users from "Christopher Thompson" <ct@arborinternet.com>     ******

I had the same experience on FreeBSD, with the:

link/inetmode.........not ok 5
server/control........not ok 6

I went ahead and installed (after manually fixing the Makefile). The
server starts up and serves pages fine. I noticed that the check script
does not work. It hangs (with -o) and eventually seems to time-out with a
link error. Probably the same error as reported by test. I have not
installed Minimate, but assume it might have problems as well.

I reported on the list before that the install script does not handle
virtual server environments where all the paths should be relative the
/usr/home/myname (including Perl and Apache). It is not clear to me
whether the link errors are from the install being bad or the virtual
server environment.


> -----Original Message-----
> From: owner-minivend-users@minivend.com
> [mailto:owner-minivend-users@minivend.com]On Behalf Of Ed LaFrance
> Sent: Wednesday, March 22, 2000 5:33 PM
> To: minivend-users@minivend.com
> Subject: [mv] [mv 4.02] - make test fails
>
>
> ******    message to minivend-users from Ed LaFrance
> <newmedia@newmediaems.com>     ******
>
> Hello all -
>
> I have seen references to this problem in general in the
> archives, but the
> solutions, when they are there, vary widely, so I though I
> would send it
> out to the list.
>
> I am trying to install minivend 4.02 on an ISP'S server, which
> is running
> BSDI BSD/OS 4.0.1. Perl 5.00503.  Things work until I get to
> make test -
> below is a snippet of terminal output:
> ------------
>
> www-pws7: {14} % make test && make install
> PERL_DL_NONLAZY=1 /usr/bin/perl -Iblib/arch -Iblib/lib
> -I/usr/libdata/perl5/5.00503/i386-bsdos -I/us
> r/libdata/perl5/5.00503 test.pl
> server/unixmode.......ok 1
> server/startup........ok 2
> link/unixmode.........ok 3
> server/inetmode.......ok 4
> link/inetmode.........not ok 5
> server/control........not ok 6
> 6 tests run -- 2/6 failed.
> *** Error code 1
>
> Stop.
> ------------
>
> The process stops right there.  I have not tried to run "make install"
> without "make test"; I don't expect that it would work too
> well.  I don't
> profess to be much of a sysadmin.  Anyone have any suggestions
> as to where
> I should start?
>
> Thanks in advance for any help that is offered.
>
> - Ed L.
>
> -
> To unsubscribe from the list, DO NOT REPLY to this message.
> Instead, send
> email with 'UNSUBSCRIBE minivend-users' in the body to
> Majordomo@minivend.com.
> Archive of past messages: http://www.minivend.com/minivend/minivend-list
>

-
To unsubscribe from the list, DO NOT REPLY to this message.  Instead, send
email with 'UNSUBSCRIBE minivend-users' in the body to Majordomo@minivend.com.
Archive of past messages: http://www.minivend.com/minivend/minivend-list