[ic] OpenBSD problems, both install and start

[Joachim Leidinger]

Mike Mehak wrote:
> 
> I'm running a clean install of openBSD  3.0.  With the needed packages
> installed such as php, mysql etc... Its only a test server so the specs are
> low, 233mhz, ~80mbs ram, and 1.2gig hard drive with a 300mb swap space.  I
> downloaded the newest version of interchange and ran the ./configure.
> Resulting in many "core dumped" messages and restarts I was finally able to
> get the whole process to finish "successfully".  I then ran the bin/makecat,
> I get the following error.
> 
> Can't use an undefined value as an ARRAY reference at
> /usr/local/interchange/lib/IniConf.pm line 438.
> 
> If I try to start the server I get "Segmentation fault (core dumped)"
> 
> I have tried recompiling perl and I have checked the perl fix for BSD with
> no luck.  I have a feeling its because of a bad install which is for either
> two reasons. Either a) bad ram/not enough (I have tried swapping it, so
> probably the latter) b) is there issues with openBSD and interchange? anyone
> else running this on openBSD?
> 
> I have tried reinstall, even formatting with no luck, any hints would be
> more than grateful, thanks, Mike

Look at

http://interchange.redhat.com/archive/interchange-users/2001/msg09422.html
http://interchange.redhat.com/archive/interchange-users/2001/msg09690.html
http://interchange.redhat.com/archive/interchange-users/2001/msg09630.html

maybe you can try it?

Joachim

-- 
Hans-Joachim Leidinger | Dipl.-Phys.Ing. Entwicklung eCommerce
[Hans-Joachim.leidinger@bpanet.de]
Black Point Arts Internet Solutions GmbH
http://www.bpanet.de